Security Bot configuration

Overview

Security Bot add-on allows your Personal Bot to act as your parcel security. Below you will find all the instructions needed to configure the add-on.

IMPORTANT: Please be advised that in-order for the add-on to work, bot must be an Estate Manager or parcel must be Group Owned and bot must have group permissions.

Security Setup

In general, there are 3 types of security modes that you can enable. You can access this page by visiting your going over to Security Bot add-on and click Use ban lists

1. Block all + allow in allowed list: Bot will not allow anyone to enter the parcel unless they're added on allowed lists (See Managing access lists below)
2. Allow all + block all in blocked list: Bot will allow everyone to enter except for those who are added on blocked list.
3. Welcome message: Bot sends this IM to anyone who lands as a greeting. Can be left blank for no greeting.
4. Warning delay: Defines the amount of time (seconds) before Warning message is sent after visitors arrival.
5. Warning message: The text that bot sends to visitor as a warning.
6. Kick delay: Defines the amount of time (seconds) before Kick message is sent after visitors arrival.
7. Kick message: The text that bot sends to visitor before kicking them.

Managing access lists

The access lists define who gets to skip the bot's security under Security Modes or fully workaround it.

• If a resident is added to blocked list: Bot will immediately eject them from parcel.
• If a resident is added to allowed list: Bot will let them enter on any conditions.

To add someone to either of the list:

1. Visit your add-on page & click Edit access lists
2. Click Add resident under corresponding list
   
3. Enter SL name and click Add avatar
   

Optionally, from the left-side you can select any of the recent visitors name.

Setting up access word

Access word is a unique feature which acts as a password. If access word is given to bot via IMs, visitor will not get ejected. This is a useful feature to allow special guests in without adding them to Access lists

To setup an Access word:

1. Visit the add-on's main page
2. Click Access word
3. Enter the special access word

Editing/removing scheduled messages

Clicking on each date of the calendar will display the list of your scheduled messages for the selected date.

To remove/edit the message:

1. Click the specific date on the calendar
2. Hover your mouse over top-right corner of the message
3. The menu of following option will appear:

• • Edit message: Takes you to message editor
  • This occurrence only (remove): Removes the message for the specified date only
  • WHOLE sequence (remove): Removes the entire periodic message